1996 johnson 9.9 outboard how to start

You are now ready to start your outboard using the following procedures specific to you model. Your iboats.

This will engage the cold-start enricher circuit. Page of 1. Manual Choke Choke plates are butterfly plates located at the back of the carburetor body. It is often the case that the choke plates are not set so they close fully and stay closed during start.

1996 johnson 9.9 outboard how to start

Post your questions, in the appropriate Forum. As the motor warms up, slowly begin reducing the fast-idle until the motor is able to run in normal idle on its own.

1996 johnson 9.9 outboard how to start

Shop Prop Finder new! The change in timing is quite noticable. Manual Primer The manual primer operates as both a fuel injector and an enriching device.

1996 johnson 9.9 outboard how to start

This is a great motor otherwise. Place the motor in fast-idle and in neutral gear. The turn it to start. Some portable tanks will often have a vent screw built into the cap, others will have auto-venting caps. The consensus was to remove it.

Five Tips For Hard Starting Outboard Motors

Pull starter rope, or press start button until the engine starts. Previous Next.

1996 johnson 9.9 outboard how to start

Do NOT tilt the motor up out of the water. After five seconds, the timing will return to normal if the engine temperature exceeds 96 degrees or if the RPM exceeds 1100, whichever occurs first. This will squirts fuel into the intake manifold. Turn the key to start.

Announcement

Those who have QuikStart may find that cold starts are better without the warm up lever, or with just a little. Ensure the fuel lines are properly attached to tank and outboard. Choke Plates:

1996 johnson 9.9 outboard how to start