Yes, it's illegal but it gets the job done. Lower 300x50. DJordan2 01-20-2012, 05: Here is a new vid I took yesterday. I have HIDs too, which is why im not sure if ima get wig wags or hide a ways, i think i like the look of hide a ways a lot better. Here's my problem, the flasher unit that I have only has two wires, blue and yellow, for each side of the high beam.
Although the flasher has additional wires for you to use to flash this light you shouldn't wire them in. Pained 10-13-2010, 11: Also make sure that wires are not coming into contact with high-temperature places like the heat sinks that some radios and sirens have.
This may be one of them. So, based on your recommendation, it would seem any flasher slower than 2 fps would do.
Even Cheaper... The original and non-complicated wide area interoperable communications system. The diagram shows only to cut one wire and splice the blue wire to the driver's side and the yellow wire to the passenger's side. I will see if I can draw something up, but for now let me try to explain: Cars that have not had consoles installed before, or the outboard door side bolts of most cars, are usually a different story and may require the liberal use of penetrating oil to loosen them up.
If you are offended by another member utilize the reporting option. You'll also want to think about flash rate...
Try to avoid removing the outboard bolts if at all possible to prevent breakage. LOL, maybe even get somebody to set on top of the truck and hold a light bar. The best place that I have found to get small external speakers that look nice, are truck stops that have stores for truckers to buy equipment.