Northwestern Pennsylvania. For FastEthernet adapters set this parameter to 5 the later is aditional info! More detailed information about all available options is provided in the online documentation , answers to frequently asked questions are available in the Optimizer FAQ , and personalized help is available through our broadband tweaking forum.
It is recommended to remove this limitation. A number that's too small risks packets being discarded before reaching their destination.
Some system processes can install port filters to block certain port ranges. Please give us more patience and focus on this thread.
In some test environments, the correct MTU entry may be offset by 8. United States English. Destination is 11 hops away Can you make any sense out of this?
The default Vista values have improved from previous Windows versions, and are usually sufficient under normal load. If you haven't registered yet, please register and log in.
If you adjust the number of TCBs the system creates as specified by the value of MaxFreeTcbs , you should also adjust the value of the hash table proportionally. Did it work for you? Sorry this didn't help. To view a list of active network interfaces and their MTU values in Vista using netsh, open command prompt as administrator and execute the following command: Note you can also set this to 1 to reduce the nagle effect from the default of 200ms without disabling it.
These should represent your typical internet or network use, as much as possible so don't measure FTP download performance if you never grab files this way in real life.
Click "Start," type CMD, right-click the cmd. Do these work for you, though? My windows 7 was sending useless packets i do not know where. I also used the netsh command to set MTU to 1500.