How to make longbow string

how to make longbow string

Step 6: Carefully pull the bundle off the jig making sure that the ends of the strings don't move. Many bows have their AMO length written, or printed, on the lower limb. Apply some temporary nock points with string or tape.

how to make longbow string

The string length is measured from the far left of post A to the far right of post D. On your string, mark where you think your nocking point will be, and mark two inches above this point and six inches below it.

Step-by-Step Tutorial. I don't want one bundle to be straight while the other is wrapped around it.

Poor Folk Bows

Figure 3. If that happens to you, don't worry about it. Apply some tension, but not so much it comes apart on you. When arrows are flying well, decide if string silencers should be used. Centre Serving Nocking Point To serve the middle of the string or the centre serving, It is usually best to take the bow string off the jig and string it to the bow.

How to Build a Flemish Twist Bow String

I use a large binder clamp. Wax well.

how to make longbow string

Determine Bow String Length If you already have a string for your bow, untwist the string and measure its length. Then serve 6 inches for the center. The first thing you have to do is put the two bundles together and measure about 7" from the end. Pull the three well twisted strands out straight and roll them clockwise so they assume the form of a rope.

How to make compound bow strings and cables

That's what holds the string together.